Difference between revisions of "Write firmware using password"
| Line 7: | Line 7: | ||
''' Scripts -> Set password''' | ''' Scripts -> Set password''' | ||
| − | + | [[File:Sfptotal-set-password.jpg]] | |
Push OK button to save changes or Cancel to close the window. | Push OK button to save changes or Cancel to close the window. | ||
| Line 15: | Line 15: | ||
'''Scripts -> Enter transceiver password -> Enable''' | '''Scripts -> Enter transceiver password -> Enable''' | ||
| − | + | [[File:Sfptotal-enter-password.jpg]] | |
You need to reset the scripts before writing with a password. | You need to reset the scripts before writing with a password. | ||
| Line 23: | Line 23: | ||
After the password is set, the programmer will write a password before performing the firmware write. | After the password is set, the programmer will write a password before performing the firmware write. | ||
| − | + | [[File:SFPTotal_Writing_Button.jpg]] | |
== Notes == | == Notes == | ||
Latest revision as of 11:36, 20 July 2016
The software supports write firmware using a password and provides a simple interface.
Software supports password length of 4 bytes (eight symbols HEX code).
You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow:
Scripts -> Set password
Push OK button to save changes or Cancel to close the window.
By default, the software produces a write firmware without using a password. You need to set a flag Enable to activate the writing with a password:
Scripts -> Enter transceiver password -> Enable
You need to reset the scripts before writing with a password.
Scripts -> Reset script
After the password is set, the programmer will write a password before performing the firmware write.
Notes
- To use this function module must support the unlocking of the table A0h when entering a password.
- Address enter the password may differ depending on the module type and vendor-specific solutions.
