Difference between revisions of "Write firmware using password"

From SFPTotal Wiki
Jump to: navigation, search
(Created page with "The software supports write firmware using a password and provides a simple interface.")
 
 
(23 intermediate revisions by the same user not shown)
Line 1: Line 1:
 
The software supports write firmware using a password and provides a simple interface.
 
The software supports write firmware using a password and provides a simple interface.
 +
 +
Software supports password length of 4 bytes (eight symbols HEX code).
 +
 +
You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow:
 +
 +
''' Scripts -> Set password'''
 +
 +
[[File:Sfptotal-set-password.jpg]]
 +
 +
Push OK button to save changes or Cancel to close the window.
 +
 +
By default, the software produces a write firmware without using a password. You need to set a flag '''Enable''' to activate the writing with a password:
 +
 +
'''Scripts -> Enter transceiver password -> Enable'''
 +
 +
[[File:Sfptotal-enter-password.jpg]]
 +
 +
You need to reset the scripts before writing with a password.
 +
 +
''' Scripts -> Reset script'''
 +
 +
After the password is set, the programmer will write a password before performing the firmware write.
 +
 +
[[File:SFPTotal_Writing_Button.jpg]]
 +
 +
== Notes ==
 +
 +
# To use this function module must support the unlocking of the table A0h when entering a password.
 +
# Address enter the password may differ depending on the module type and vendor-specific solutions.

Latest revision as of 11:36, 20 July 2016

The software supports write firmware using a password and provides a simple interface.

Software supports password length of 4 bytes (eight symbols HEX code).

You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow:

Scripts -> Set password

Sfptotal-set-password.jpg

Push OK button to save changes or Cancel to close the window.

By default, the software produces a write firmware without using a password. You need to set a flag Enable to activate the writing with a password:

Scripts -> Enter transceiver password -> Enable

Sfptotal-enter-password.jpg

You need to reset the scripts before writing with a password.

Scripts -> Reset script

After the password is set, the programmer will write a password before performing the firmware write.

SFPTotal Writing Button.jpg

Notes

  1. To use this function module must support the unlocking of the table A0h when entering a password.
  2. Address enter the password may differ depending on the module type and vendor-specific solutions.