Difference between revisions of "Write firmware using password"
From SFPTotal Wiki
| Line 1: | Line 1: | ||
The software supports write firmware using a password and provides a simple interface. | The software supports write firmware using a password and provides a simple interface. | ||
| − | Software supports password length of 4 bytes. | + | Software supports password length of 4 bytes (eight symbols HEX codes). |
You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow: | You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow: | ||
Revision as of 11:29, 20 July 2016
The software supports write firmware using a password and provides a simple interface.
Software supports password length of 4 bytes (eight symbols HEX codes).
You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow:
Scripts -> Set password
Push OK button to save changes or Cancel to close the window.
By default, the software produces a write firmware without using a password. You need to set a flag to activate the account with a password:
Scripts -> Enter transceiver password -> Enable
You need to reset the scripts before writing with a password.
Scripts -> Reset script
Notes
- To use this function module must support the unlocking of the table A0h when entering a password.
- Address enter the password may differ depending on the module type and vendor-specific solutions.
