Difference between revisions of "Write firmware using password"

From SFPTotal Wiki
Jump to: navigation, search
Line 22: Line 22:
  
 
# To use this function module must support the unlocking of the table A0h when entering a password.
 
# To use this function module must support the unlocking of the table A0h when entering a password.
 +
# Address enter the password may differ depending on the module type and vendor-specific solutions.

Revision as of 11:28, 20 July 2016

The software supports write firmware using a password and provides a simple interface.

Software supports password length of 4 bytes.

You can set a password that will be used to unlock the module firmware before recording. To set a password, and set the memory area to enter the password follow:

Scripts -> Set password

Sfptotal-set-password.jpg

Push OK button to save changes or Cancel to close the window.

By default, the software produces a write firmware without using a password. You need to set a flag to activate the account with a password:

Scripts -> Enter transceiver password -> Enable

You need to reset the scripts before writing with a password.

Scripts -> Reset script

Notes

  1. To use this function module must support the unlocking of the table A0h when entering a password.
  2. Address enter the password may differ depending on the module type and vendor-specific solutions.