Difference between revisions of "Write firmware to the transceiver's memory"

From SFPTotal Wiki
Jump to: navigation, search
(Programming using scripts)
Line 9: Line 9:
 
When the first option does not work for the selected transceiver, writing into memory is made with a special set of commands (scripts) that are sent to the programmer for a
 
When the first option does not work for the selected transceiver, writing into memory is made with a special set of commands (scripts) that are sent to the programmer for a
 
realization of custom writing algorithm, supported bytransceiver.
 
realization of custom writing algorithm, supported bytransceiver.
 +
 +
The basic set of scripts for writing the firmware to the memory of the transceivers from different manufacturers is supplied with the program.

Revision as of 15:37, 20 November 2015

Due to mismatch of the majority of the modules to the MSA standards because of installed special controllers or use non-standard ways of writing firmware into transceiver’s memory by the manufacturers, SFPTotal software implements two different approaches.

Programming according to MSA standards

If transceiver supports writing the memory according to the MSA standards for the selected type of module, software sends a command to the programming board that implements the algorithm of writing into the memory.

Programming using scripts

When the first option does not work for the selected transceiver, writing into memory is made with a special set of commands (scripts) that are sent to the programmer for a realization of custom writing algorithm, supported bytransceiver.

The basic set of scripts for writing the firmware to the memory of the transceivers from different manufacturers is supplied with the program.