Difference between revisions of "Validation firmware checksum"

From SFPTotal Wiki
Jump to: navigation, search
Line 5: Line 5:
 
By the default, software automatically recalculates checksum when you changed the firmware in the tables.  
 
By the default, software automatically recalculates checksum when you changed the firmware in the tables.  
  
To disable the automatic checksum verification, deselect flag in menu '''Options -> Auto set checksum'''.
+
To disable the automatic checksum validation, deselect flag in menu '''Options -> Auto set checksum'''.
  
 
[[File:SFPTotal autoset fitmware checksum.png]]
 
[[File:SFPTotal autoset fitmware checksum.png]]

Revision as of 15:59, 17 November 2015

This function allows you to create a firmware with correct checksum after any changes.

In the body of firmware transceiver there are two checksum that define data integrity of the firmware body. In the tabs FIRMWARE DETAIL and TABLE checksum bytes have addresses 0x3F and 0x5F.

By the default, software automatically recalculates checksum when you changed the firmware in the tables.

To disable the automatic checksum validation, deselect flag in menu Options -> Auto set checksum.

SFPTotal autoset fitmware checksum.png

To validate the checksum in the current firmware, you must use menu item Edit -> Checksum.

SFPTotal set checksum.png

When pushed, the program will compare checksum values and highlight the cells with green if checksum is correct and red if not.

SFPTotal validate checksum.png

To set correct checksum value in the body of the firmware, click button:

SFPTotal set checksum button.png

After this there will be a recalculation of all checksums.

SFPTotal validate checksum result.png