Difference between revisions of "Read from transceiver"
From SFPTotal Wiki
| Line 2: | Line 2: | ||
: 1. Connect a programming board to PC and run software SFPTotal Wizard. | : 1. Connect a programming board to PC and run software SFPTotal Wizard. | ||
| + | |||
: [[File:Read-code-from-transceiver-step1.jpg]] | : [[File:Read-code-from-transceiver-step1.jpg]] | ||
: 2. Select '''Module type''' | : 2. Select '''Module type''' | ||
| + | |||
: [[File:Read-code-from-transceiver-step2.jpg]] | : [[File:Read-code-from-transceiver-step2.jpg]] | ||
: 3. Select '''Address table''' for reading | : 3. Select '''Address table''' for reading | ||
| + | |||
: [[File:Read-code-from-transceiver-step4.jpg]] | : [[File:Read-code-from-transceiver-step4.jpg]] | ||
| − | : 4. | + | : 4. Push button '''Read from transceiver''' |
| + | |||
: [[File:Read-code-from-transceiver-step3.jpg]] | : [[File:Read-code-from-transceiver-step3.jpg]] | ||
[[File:Read-code-from-transceiver-step5.jpg]] | [[File:Read-code-from-transceiver-step5.jpg]] | ||
Revision as of 15:57, 27 July 2018
Follow next steps to do the reading a code from transceiver's memory:
- 1. Connect a programming board to PC and run software SFPTotal Wizard.
- 2. Select Module type
- 3. Select Address table for reading
- 4. Push button Read from transceiver
