Difference between revisions of "Read from transceiver"
From SFPTotal Wiki
| Line 1: | Line 1: | ||
Follow next steps to do the reading a code from transceiver's memory: | Follow next steps to do the reading a code from transceiver's memory: | ||
| − | + | : 1. Connect a programming board to PC and run software SFPTotal Wizard. | |
: [[File:Read-code-from-transceiver-step1.jpg]] | : [[File:Read-code-from-transceiver-step1.jpg]] | ||
| − | |||
| − | [[File:Read-code-from-transceiver-step2.jpg]] | + | : 2. Select '''Module type''' |
| + | : [[File:Read-code-from-transceiver-step2.jpg]] | ||
| − | Select '''Address table''' for reading | + | : 3. Select '''Address table''' for reading |
| + | : [[File:Read-code-from-transceiver-step4.jpg]] | ||
| − | + | : 4. Plug-in a transceiver to the programmer's port and push button '''Read from transceiver''' | |
| − | + | : [[File:Read-code-from-transceiver-step3.jpg]] | |
| − | Plug-in a transceiver to the programmer's port and push button '''Read from transceiver''' | + | |
| − | + | ||
| − | [[File:Read-code-from-transceiver-step3.jpg]] | + | |
[[File:Read-code-from-transceiver-step5.jpg]] | [[File:Read-code-from-transceiver-step5.jpg]] | ||
Revision as of 15:57, 27 July 2018
Follow next steps to do the reading a code from transceiver's memory:
- 1. Connect a programming board to PC and run software SFPTotal Wizard.
-
- 2. Select Module type
-
- 3. Select Address table for reading
-
- 4. Plug-in a transceiver to the programmer's port and push button Read from transceiver
-
