Difference between revisions of "User interface"
From SFPTotal Wiki
| Line 16: | Line 16: | ||
:*Write firmware to the transceivers memory. | :*Write firmware to the transceivers memory. | ||
| − | + | == Module type selector == | |
::[[File:SFPTotal Module type selector 2.jpg]] | ::[[File:SFPTotal Module type selector 2.jpg]] | ||
| + | |||
| + | == Firmware table tab == | ||
::[[File:SFPTotal Table of firmware.jpg]] | ::[[File:SFPTotal Table of firmware.jpg]] | ||
| + | |||
| + | == Firmware detail tab == | ||
::[[File:SFPTotal Table of firmware detail.jpg]] | ::[[File:SFPTotal Table of firmware detail.jpg]] | ||
::[[File:SFPTotal Table of firmware detail 2.jpg]] | ::[[File:SFPTotal Table of firmware detail 2.jpg]] | ||
| + | |||
| + | == Batch loader tab == | ||
::[[File:SFPTotal Tab of batch loader.jpg]] | ::[[File:SFPTotal Tab of batch loader.jpg]] | ||
Revision as of 16:32, 20 November 2015
The user interface is divided into two sections.
The unit of features and management is equipped with a buttons of quick access, menu of receiver type selection and tables, as well as with a block of special tabs.
Contents
Control buttons
- The buttons of quick access perform the following functions:
- Clear table with firmware (Table tab);
- Import firmware from a file located on your hard drive to a table (Table tab);
- Export firmware from table (Table tab) to the file;
- Firmware checksum validation;
- Reading firmware from memory of the transceiver and;
- Write firmware to the transceivers memory.
