Difference between revisions of "Read from transceiver"
From SFPTotal Wiki
| (9 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Follow next steps to do the reading a code from transceiver's memory: | Follow next steps to do the reading a code from transceiver's memory: | ||
| − | + | : 1. Connect a programming board to PC and run software SFPTotal Wizard. | |
| − | + | : [[File:Read-code-from-transceiver-step1.jpg]] | |
| − | |||
| − | Select ''' | + | : 2. Select '''Module type''' |
| − | [[File:Read-code-from-transceiver- | + | : [[File:Read-code-from-transceiver-step2.jpg]] |
| − | |||
| − | + | : 3. Select '''Address table''' for reading | |
| − | [[File:Read-code-from-transceiver-step5.jpg]] | + | : [[File:Read-code-from-transceiver-step4.jpg]] |
| + | |||
| + | |||
| + | : 4. Push button '''Read from transceiver''' | ||
| + | |||
| + | : [[File:Read-code-from-transceiver-step3.jpg]] | ||
| + | |||
| + | |||
| + | : 5. Result of reading will be returned to software's window. Data will be presented in HEX and ASCII grids. | ||
| + | : If the data have been read without any error, software will show READ OK in operation log area. | ||
| + | |||
| + | : [[File:Read-code-from-transceiver-step5.jpg]] | ||
Latest revision as of 16:00, 27 July 2018
Follow next steps to do the reading a code from transceiver's memory:
- 1. Connect a programming board to PC and run software SFPTotal Wizard.
- 2. Select Module type
- 3. Select Address table for reading
- 4. Push button Read from transceiver
- 5. Result of reading will be returned to software's window. Data will be presented in HEX and ASCII grids.
- If the data have been read without any error, software will show READ OK in operation log area.
