Difference between revisions of "User interface"
From SFPTotal Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
== Control buttons == | == Control buttons == | ||
| + | : The buttons of quick access perform the following functions: | ||
:[[File:SFPTotal Main buttons panel.jpg]] | :[[File:SFPTotal Main buttons panel.jpg]] | ||
| − | |||
:*Clear table with firmware (Table tab); | :*Clear table with firmware (Table tab); | ||
| − | :*Import firmware from a file located on your hard drive to | + | :*Import firmware from a file, located on your hard drive, to the table (Table tab); |
:*Export firmware from table (Table tab) to the file; | :*Export firmware from table (Table tab) to the file; | ||
:*Firmware checksum validation; | :*Firmware checksum validation; | ||
Latest revision as of 16:35, 20 November 2015
The user interface is divided into two sections.
The unit of features and management is equipped with a buttons of quick access, menu of receiver type selection and tables, as well as with a block of special tabs.
Contents
Control buttons
- The buttons of quick access perform the following functions:
- Clear table with firmware (Table tab);
- Import firmware from a file, located on your hard drive, to the table (Table tab);
- Export firmware from table (Table tab) to the file;
- Firmware checksum validation;
- Reading firmware from memory of the transceiver and;
- Write firmware to the transceivers memory.
