Difference between revisions of "User interface"
From SFPTotal Wiki
| (8 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
The unit of features and management is equipped with a buttons of quick access, menu of receiver type selection and tables, as well as with a block of special tabs. | The unit of features and management is equipped with a buttons of quick access, menu of receiver type selection and tables, as well as with a block of special tabs. | ||
| − | + | == Control buttons == | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | ::[[File:SFPTotal Main buttons panel.jpg]] | + | : The buttons of quick access perform the following functions: |
| + | |||
| + | :[[File:SFPTotal Main buttons panel.jpg]] | ||
| + | |||
| + | :*Clear table with firmware (Table tab); | ||
| + | :*Import firmware from a file, located on your hard drive, to the table (Table tab); | ||
| + | :*Export firmware from table (Table tab) to the file; | ||
| + | :*Firmware checksum validation; | ||
| + | :*Reading firmware from memory of the transceiver and; | ||
| + | :*Write firmware to the transceivers memory. | ||
| + | |||
| + | == Module type selector == | ||
::[[File:SFPTotal Module type selector 2.jpg]] | ::[[File:SFPTotal Module type selector 2.jpg]] | ||
| + | |||
| + | == Firmware table tab == | ||
::[[File:SFPTotal Table of firmware.jpg]] | ::[[File:SFPTotal Table of firmware.jpg]] | ||
| − | + | == Firmware detail tab == | |
::[[File:SFPTotal Table of firmware detail 2.jpg]] | ::[[File:SFPTotal Table of firmware detail 2.jpg]] | ||
| + | |||
| + | == Batch loader tab == | ||
::[[File:SFPTotal Tab of batch loader.jpg]] | ::[[File:SFPTotal Tab of batch loader.jpg]] | ||
Latest revision as of 16:35, 20 November 2015
The user interface is divided into two sections.
The unit of features and management is equipped with a buttons of quick access, menu of receiver type selection and tables, as well as with a block of special tabs.
Contents
Control buttons
- The buttons of quick access perform the following functions:
- Clear table with firmware (Table tab);
- Import firmware from a file, located on your hard drive, to the table (Table tab);
- Export firmware from table (Table tab) to the file;
- Firmware checksum validation;
- Reading firmware from memory of the transceiver and;
- Write firmware to the transceivers memory.
