Difference between revisions of "Read from transceiver"
From SFPTotal Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 22: | Line 22: | ||
: 5. Result of reading will be returned to software's window. Data will be presented in HEX and ASCII grids. | : 5. Result of reading will be returned to software's window. Data will be presented in HEX and ASCII grids. | ||
| + | : If the data have been read without any error, software will show READ OK in operation log area. | ||
: [[File:Read-code-from-transceiver-step5.jpg]] | : [[File:Read-code-from-transceiver-step5.jpg]] | ||
Latest revision as of 16:00, 27 July 2018
Follow next steps to do the reading a code from transceiver's memory:
- 1. Connect a programming board to PC and run software SFPTotal Wizard.
- 2. Select Module type
- 3. Select Address table for reading
- 4. Push button Read from transceiver
- 5. Result of reading will be returned to software's window. Data will be presented in HEX and ASCII grids.
- If the data have been read without any error, software will show READ OK in operation log area.
